s&m® labor can be prepared with cold, warm and hot water.
Clouding of the solution does not mean that the cleaning
performance is affected.
Immerse the instruments into the stock solution immediately
after use for a contact time of approx. 10 minutes.
The instruments to be cleaned must be fully covered. In case
of low impurities, reduce the dose and/or contact time, increase
them in case of obstinate impurities and, if applicable, use an
instrument brush in addition.
Rinse thoroughly afterwards.
Daily renewal of the stock solution is recommended.
s&m® labor is also suitable for use in an ultrasonic bath.
Laboratory tests are not affected as s&m® labor can be rinsed
off without leaving any residues. Even sensitive enzymatic or
serologic reactions are not influenced if distilled water is used
to rinse afterwards.