perform® select soproper
Ready to use peracetic acid solution using vaporisation technology for bio-decontamination of surfaces
Our Plus
- Ready to use
- Residue free after vaporisation
- efficacy tested according to European norms (EN)
Downloads
Fields of Application
Bio-decontamination of isolators and material transfer chambers by vaporisation technology.
Instructions for use
Vaporise perform® select soproper undiluted. Quantities and times are to be validated on site. Surfaces should be precleaned. Please follow isolator or material transfer chambers manufacturer's instructions.
Leaves no residues on disinfected surfaces.
Microbiological effectiveness is extremely comprehensive (incl. spores) and depends on the vaporisation technology used.
Application parameters including required contact time are dependent upon the vaporisation technology used and are determined by the local conditions of the area to be disinfected, such as size, fittings, temperature, atmospheric humidity.
Leaves no residues on disinfected surfaces.
Microbiological effectiveness is extremely comprehensive (incl. spores) and depends on the vaporisation technology used.
Application parameters including required contact time are dependent upon the vaporisation technology used and are determined by the local conditions of the area to be disinfected, such as size, fittings, temperature, atmospheric humidity.
Microbiological efficacy
| Efficacy | Concentration | Contact time |
|---|---|---|
| bactericidal EN1276, EN13697 | ready-to-use 20 °C | 30 sec. |
| fungicidal EN1650, EN13697 | ready-to-use 20 °C | 30 sec. |
| sporicidal EN13704 | ready-to-use 20 °C | 30 sec. |
Product data
Composition:
100 g solution contains the following active substances: 3.5 g Peracetic Acid
100 g solution contains the following active substances: 3.5 g Peracetic Acid
Chemical-physical data
Density:1,075 g/cm3 / 20 °C
Flash point:> 100 °C
Form:liquid
Color:colourless
Viscosity, dynamic:1,54 mPa*s / 20 °C
pH:< 1 / 20 °C
Special advice
Use disinfectants safely. Always read the label and product information before use.
Good material compatibility with stainless steel, IIR, PVC soft, SI, PEHD, glass, etc. Contact with non-ferrous metals (brass, copper) should be avoided. Recommended storage temperature 5 - 25 °C. Carry and store product container in an upright position.
Good material compatibility with stainless steel, IIR, PVC soft, SI, PEHD, glass, etc. Contact with non-ferrous metals (brass, copper) should be avoided. Recommended storage temperature 5 - 25 °C. Carry and store product container in an upright position.
Environmental information
schülke manufactures products economically and with advanced, safe and environmentally friendly production processes while at the same time maintaining our high quality standards.
