perform® ID is an aldehyde-free disinfectant based on active oxygen for the disinfection of dental impressions.

Our Plus

bactericidal, levurocidal and virucidal spectrum of efficacy

Fields of Application

For the disinfection of dental impressions made from silicon and polyether.

Instructions for use

The efficacy of the working solution compound stays stable for the duration of 1 working day and therefore guarantees full microbiological efficacy during this period. Only in case of excessive soiling the working solution should be changed in shorter intervals. Considering hygienic aspects and in order to avoid bacteria- and infection transmission, the disinfection of dental impressions should always be effected at the dental practice prior to the transfer of the impressions to the dental laboratory. If the dental laboratory is not sure, if the impressions have been disinfected, a disinfection of the material from the practice should be effected in all instances.

Dosing and use:
Rinse the impressions under running water. Dissolve 2 level measuring scoops of the product in 2 litres water (= 2 % solution). Place the impression in the solution, leave to react for the mentioned time and then rinse the pieces again under running water.

Microbiological efficacy

EfficacyConcentrationContact time
EN13727, EN14561
- clean conditions
2 % (20 ml/l)15 min.
EN13624, EN14562
- clean conditions
2 % (20 ml/l)15 min.
virucidal against enveloped viruses
- clean conditions
2 % (20 ml/l)15 min.
- clean conditions
2 % (20 ml/l)15 min.

Product data

100 g granules contains the following active substances: 45 g Pentapotassium bis(peroxymonosulphate)bis(sulfate)
Labelling according to Regulation (EC) No 648/2004:
5 - 15 % anionic surfactants; < 5 % non-ionic surfactants; < 5 % soap and phosphonates, perfumes

Chemical-physical data

Flash point:Not applicable
Viscosity, dynamic:Not applicable
pH:ca. 4 / 5 g/l / 20 °C / in water

Special advice

Always read label and product information before use.
During the disinfection of impressions with the product the prescribed application concentration as well as the reaction time in the immersion bath should be particularly observed. Do not ingest. Avoid contact with skin and eyes. Rinse the affected body parts with plenty of water. We recommend using gloves when handling the product. The solution may act as a bleach on sensitive textiles. Keep container tightly closed. Protect from frost, heat and sunlight. Store at room temperature in the original container. Only recycle completely emptied packaging. Leftover product can be disposed of with household waste. Ensure adequate ventilation at the site of use. For professional use only. Not for final disinfection of semicritical and critical medical devices.

Information for order

ItemDelivery formItem no.
perform® ID tin (900g)4/cartonon request
perform® ID bag (120 x 40g)1/cartonon request
These products are not available in every country. For more information please contact our local subsidiary or distributor.

Environmental information

schülke manufactures products economically and with advanced, safe and environmentally friendly production processes while at the same time maintaining out high quality standards.
CE 0297

Privacy Policy

We use analysis methods (e. g. cookies) to measure how often our site is visited and how it is used.
We embed third-party content from other providers (e. g. videos) on our site. We have no influence on further data processing and any tracking by the third party provider.
In this context, we also use service providers in third countries outside the EU that do not have an adequate level of data protection, which harbors the following risks: Access by authorities without informing the data subject, no data subject rights, no legal remedies, loss of control.
With your settings you consent to the processes described above. You can revoke your consent with effect for the future. You can find more information in our privacy policy.